Using Mobility Print from iOS and iPadOS
This document provides instructions for how to use Mobility Print from an iOS or iPad device. The intended audience is an end user.
Information
Important! In order to add the WolfPrint printers for Mobility Print during setup, your device must be on the NC State network. On-campus users connect to the NC State wireless network and use eduroam or ncsu. Off-campus users connect using NC State's VPN Service.
Mobility Print works just like AirPrint on iOS and iPadOS. Once your device is connected to the NC State network, no additional setup is required.
Print using the WolfPrint FollowMe Printers
- Print like you normally would from your device, selecting the desired WolfPrint FollowMe Printer.
- When prompted, login with your Unity ID and password.
Important! After your print job is submitted, you must confirm it within 10 minutes by following the steps below; otherwise, it will automatically be removed from the system.
Confirm and Release your print job
- Open the PaperCut Web Client.
- Log in with your Unity ID and password.
- After a few seconds, you should get a Print Job Notification pop up.
- Select the PaperCut account to charge and then click Print.
- Another pop-up message should appear, indicating that your file is ready to print on a FollowMe printer.
- Click OK and then locate a WolfPrint FollowMe printer to release your job from.
Visit the Apple Support site for more help Using AirPrint to print from your iPhone, iPad, or iPod touch.
Escalation
Any questions on content or process within this document should be escalated via Incident to OIT_WOLFPRINT.
Related Documentation
https://support.apple.com/en-au/109349
Title: Using Mobility Print from iOS and iPadOS
Service: WolfPrint
Template if applicable: MDS Public Knowledge
Assignment Group(s): OIT_WolfPrint
Document Owner: Kathy Weiss, Tom Farwig
Available Priorities: Low
Keywords: WolfPrint, Mobility, Print, BYOD, iOS, iPadOS, iphone,