Mobility Print for Android

Using Mobility Print from Android

Important!  In order to add the WolfPrint printers for Mobility Print during setup, your device must be on the NC State network.  On-campus users, connect to the NC State wireless network and use eduroam or ncsu. Off-campus users, connect using NC State's VPN Service.

• Setting Up Mobility Print
• 
  
  1. Install the Mobility Print Android App from the Google Play Store.
  2. Tap Open.
  3. Tap and check the Mobility Print Service is on.
  4. If not, Tap the enable toggle.
  5. Tap Mobility Print and verify the four WolfPrint Printers are found.

Submit your file(s) to Print

• Print like you normally would from your device, selecting the desired WolfPrint FollowMe Printer.
• When prompted, enter your Unity ID and password.

Important!  After your print job is submitted, you must confirm it within 10 minutes by following the steps below; otherwise, it will automatically be removed from the system.

Confirm and Release your print job

• Open the PaperCut Web Client at go.ncsu.edu/wolfprint.
• Log in with your Unity ID and password.
• After a few seconds, you should get a Print Job Notification pop up. 
• Select the PaperCut account to charge and then click Print.
• Another pop-up message should appear, indicating that your file is ready to print on a FollowMe printer.  
• Click OK and then located a WolfPrint FollowMe printer to release your job from.